Sears 247.37033 - Manual (Page 7)

ASSEMBLY
REMOVING UNIT FROM CARTON
• Remove staples, break glue on top flaps, or cut
tape at carton end and peel along top flap to
open carton.
• Remove loose parts if included with unit (i.e.,
owner's manual, etc.). See Figure 1.
Figure 1
• Cut along dotted lines and lay carton down flat.
• Remove packing material.
• Roll or slide unit out of carton. Check carton
thoroughly for loose parts. See Figure 1.
Note; Make sure not to crimp the cables while
removing the loose parts or the entire unit from the
carton.
IMPORTANT: This unit is shipped without gasoiine
or oii in the engine. Be certain to service engine with
gasoline and oil before operating your mower.
NOTE: Reference to right or left hand side of the
mower and front or rear of the mower is observed
from the operating position.
LOOSE PARTS
a. Side Discharge Chute
b. Owner’s Manual
c. A Bottle of Engine Oil
TOOLS REQUIRED
a. Pair of Pliers
b. Funnel
DISCONNECTING SPARK PLUG
® Before setting up your lawn mower, disconnect
the spark plug wire from the spark plug, and
ground it against the engine. See Figure 2.
« Attach rubber boot to a bolt on the engine to
ground.
ASSEMBLING HANDLE
» Raise the lower handle as shown in Figure 3A so
that the lower handle snaps into place.
1. Raise lower handle