XMART Optima 10K 2PH - Manual (Page 41)

User Manual
- UPS ONLINE 6K/10K 2Ph
ENGLISH
_____________________________________________________________________________________________________________________
20140714_ 6K-10K 2PH (EN) - 41
 14: Charger output voltage adjustment
Interface Setting
Parameter 2: you may choose Add or Sub to adjust charger voltage output
Parameter 3: the voltage range is from 0V to 9.9V, the default value is 0V.
NOTE: *Before making voltage adjustment, be sure to disconnect all batteries first to
get the accurate charger voltage. *We strongly suggest to use the default value (0).
Any modification should be suitable to battery specifications.
 15: Inverter 1 output voltage adjustment (Note: available after March-2012)
Interface Setting
Parameter 2: you may choose Add or Sub to adjust inverter1 voltage
Parameter 3: the voltage range is from 0V to 9.9V, the default value is 0V.
 16: Inverter 2 output voltage adjustment (Note: available after March-2012)
Interface Setting
Parameter 2: you may choose Add or Sub to adjust inverter2 voltage
Parameter 3: the voltage range is from 0V to 9.9V, the default value is 0V.
 17: FAN Speed Adjustment
Interface Setting
Parameter 2: Indicates always FAN
Parameter 3:
ATO: It will allow FAN to adjust its speed automatically according to cooling
needs.
FUL: It will force FAN at full speed under any condition.
This function must be in ATO mode. Any other configuration for service center
only.
 18: AC Voltage Meter Calibration for L1
Interface Setting
AC voltage value for L1 output indicated on LCD can be adjusted by this
function.
Parameter 2: you may choose Add (to increase) or Sub (to reduce) to adjust
inverter1 voltage
Parameter 3: the voltage range is from 0V to 9.9V, the default value is 0V.
 19: AC Voltage Meter Calibration for L2
Interface Setting
AC voltage value for L2 output indicated on LCD can be adjusted by this
function.
Parameter 2: you may choose Add (to increase) or Sub (to reduce) to adjust
inverter1 voltage
Parameter 3: the voltage range is from 0V to 9.9V, the default value is 0V.