XMART Optima 10K 2PH - Manual (Page 31)

User Manual
- UPS ONLINE 6K/10K 2Ph
ENGLISH
_____________________________________________________________________________________________________________________
20140714_ 6K-10K 2PH (EN) - 31
UPS FRONT PANEL: LED INDICATOR LIGHTS
There are 4 LED indication lights in front panel, located below LCD. These 4 LEDs describe UPS condition as follow:
MODE Bypass Line Battery Fault
UPS is in Auto-check mode
● ● ● ●
BYPASS Mode
● ○ ○ ○
NORMAL Mode
○ ● ○ ○
BATTERY Mode
○ ○ ● ○
BATTERY TEST in progress
● ● ● ○
ECO Mode Activated
● ● ○ ○
UPS in Failure
○ ○ ○ ●
●
LED = ON /
○
LED = OFF
UPS FRONT PANEL: LCD
This UPS has a sophisticated LCD able to display all important information related to input line, UPS status and values,
operation mode and error and alarm messages. It is a powerful information tool to know what is happening at any moment.
LCD is also the configuration interface for all configurable parameters.
1.- BATTERY INFORMATION: In this section is displayed battery charging level and battery alarms/error icons.
2.- ELAPSED TIMER: When UPS switches to battery mode, elapsed time during battery mode is displayed in
Hours/Minutes/Seconds.
3.- ERROR / ALARM CODE: In case of alarm or error, 2 digits code is displayed in this section to describe the kind of error or
alarm. Revise error and alarm codes tables in this manual.
4.- BEEP STATUS: It shows if audible alarm buzzer is active or muted.
5.- LOAD INFORMATION: In this section is displayed load value connected to UPS by 4 segments displays:
(0-25%), (25%-50%), (50%-75%) and (75%-100%). It also shows error and alarm icons related to UPS output.
6.- UPS MODE: All possible UPS modes are indicated by this section in graphic way.
7.- INPUT / OUTPUT VALUES: Input and output voltage and frequency values can be monitored in this LCD section. In battery
mode this section shows battery DC voltage.