Winco Mfg. 6240 - Inverness 24 Hour Treatment Recliner - Manual (Page 8)

Copyright 2014, WINCO MFG., LLC 8
ATTENDANT OPERATING INSTRUCTIONS
RECLINE CHAIR FROM ATTENDANT POSITION:
Attendant should be positioned on the RIGHT or LEFT side of chair
1. While occupant is seated in the chair, use one hand to operate the
recline lever, located on either side of chair, to activate the legrest
into its raised position.
2. To operate the infinite back positioning, after occupant's feet have
been raised, use one hand to operate the recline lever (A) and the
other hand to push on the upholstered back (B) until desired position
or maximum recline has been reached.
Release recline lever (A) to maintain position.
IMPORTANT:
•
Do NOT force the back of chair up or down without fully extend-
ing either of the two recline levers, this can damage the chair.
2
RETURN CHAIR UPRIGHT FROM ATTENDANT POSITION:
Attendant should be positioned on the RIGHT or LEFT side of chair
1. While occupant is reclined in the chair, attendant should use one
hand to operate the recline lever (A), located on either side of chair,
while using the other hand to pull up on back (B).
Release the recline lever (A) once the back has fully returned to the
upright position.
2. Attendant should use one hand to push down on the legrest (A) until
it locks into its stored position.
NOTE: The recline lever does NOT have to be used to return legrest
to its stored position.
WARNING:
•
Attendant should NOT use foot to return the legrest to it's stored
position. Damage to mechanism may occur.
2
1 A
A
1 A