Winco Mfg. 6240 - Inverness 24 Hour Treatment Recliner - Manual (Page 5)

Copyright 2014, WINCO MFG., LLC 5
ASSEMBLY INSTRUCTIONS
BACK ASSEMBLY INSTRUCTIONS:
1. Lock ALL (4) casters on chair base. (See Lock/Unlock
Casters pg.7)
IMPORTANT:
•
Keep objects and persons clear of the chair before per-
forming step 2.
2. Pull one of the recline levers (A), located on either side of
the chair, until fully extended to bring the recline mechanism
(B) into its upright position.
NOTE: Legrest is spring loaded and will be rapidly released
into the recline position when recline lever is pulled.
3. Release the recline lever and push legrest in, to its stored
position.
4. Hold the rear apron up, exposing the mounting brackets
(A). Lift the upholstered back by its sides while aligning the
mounting brackets with the recline mechanism (B).
WARNING:
•
Keep hands clear of connection points or injury may
occur
IMPORTANT:
•
We recommend two people be used for step 4
• Be careful not to tear or puncture vinyl.
PREPARATION:
1. Carefully examine your product for any damage. Inspect all components.
IF DAMAGE IS EVIDENT, REFUSE SHIPMENT, & CONTACT FREIGHT CARRIER OR WINCO IMMEDIATELY.
2. Remove all packaging material that was secured for shipping.
3. Carefully remove the product from the carton.
4. Save all boxes and packaging material until after you have assembled your product and have verified that all com-
ponents are functioning properly.
2
1
A
4