Winco Mfg. 8550SH - Recovery Couch with Shelf - Manual

Page 1 of 4
006070 Rev R Date 06-06-12 JWC
1. READ AND FOLLOW ALL DIRECTIONS.
2. NEVER stand on table or INJURY MAY OCCUR.
3. NEVER allow user to sleep unattended on table or INJURY MAY OCCUR.
4. NEVER leave an unconscious user unattended on table or INJURY MAY OCCUR.
5. DO NOT use table for transporting user in or with ANY type of vehicle or trailer. Winco tables have not been tested
or approved for use by an occupant in any type of vehicle or trailer.
6. NEVER leave an infant or child unattended on table or INJURY MAY OCCUR.
7. Periodically, recheck tightness of all nuts, bolts and screws.
8. USE ONLY WINCO AUTHORIZED REPLACEMENT PARTS.
9. NEVER EXCEED the recommended weight capacity of 400 lbs. (181.4 kg).
10. SAVE THESE INSTRUCTIONS for future reference and training.
8550
Recovery Couch
CUSTOMER INSTRUCTIONS
Tools needed:
 Phillips-head
screwdriver
 7/16” wrench (multiple size wrench included)
 Scissors or box cutter
 Cardboard shipping container (stays under table during assembly to protect upholstery)
 - If using powered tools, always start hardware together by hand first & wear safety goggles
SEE “Parts Reference” (pg.3) for visual reference during assembly.
1. After checking your product for any shipping damage, table needs to be positioned upside-down on cardboard or
protective surface. Remove all packing material and hardware that was secured for shipping. Cut tape on corners of
box so that cardboard will lay flat while you assemble table.
2. You will find two Table Legs, in-between and attached to the Table Frame Rails. Pivot up the (2) Table Legs.
NOTE: The table legs have braces that need to align with two threaded holes in the wood
of the Upholstered Top.
3. Install (4) ¼-20 x 1-½” screws through (2) holes in each Upper Leg Brace of the Table Legs, and into (2) threaded
holes (each end) in the wood of the Upholstered Top.
NOTE: Do not fully tighten at this time.
4. Place (4) ¼-20 x 1-½” carriage bolts into the (4) holes through the Lower Leg Brace of the Table Legs.
Heads of screws should face the ends of table, for better appearance.
5. Align the Cross-brace (smoothest side up) with the (4) screws that you just installed on step 4,
and fasten with (4) ¼-20 nuts.
PLEASE READ AND FAMILIARIZE YOURSELF WITH ALL INSTRUCTIONS BEFORE PROCEEDING WITH ASSEMBLY
PLEASE READ AND FAMILIARIZE YOURSELF WITH ALL INSTRUCTIONS BEFORE USING THIS PRODUCT.
If you have trouble understanding these instructions contact your dealer or Winco customer support, (800) 237-3377
before attempting to use this product; otherwise injury may occur.
8550 Weight Capacity = 400 lbs. (181.4 kg.)
Winco assumes no responsibility for damage or injury caused by improper assembly,
installation, use, or maintenance of these products.