Winco Mfg. 3409 - PRIVESS SWING-AWAY Privacy Screen with Sure-Chek - Manual

Page 1 of 4
006245 Rev K Date 06-26-13 JWC
1. READ AND FOLLOW ALL DIRECTIONS.
2. NEVER hang equipment or personal objects from Curtain Rod; Screen could fall and INJURY MAY OCCUR.
3. NEVER place screen near open flame or over a radiator or heat register.
4. NEVER place screen in front of a door or exit sign; In case of emergency screen could block or hinder
evacuation.
5. SUFFOCATION DANGER to children; Screen could block nose and mouth and prevent breathing. VINYL
SCREEN IS NOT A TOY.
6. DO NOT allow children to play with, or climb on screen; Screen could fall and SERIOUS INJURY MAY
OCCUR.
7. Periodically, recheck tightness of mounting screws.
8. ALWAYS mount at least two mounting screws to a wall stud, “dead wood” or other solid wall structure;
DO NOT attach to drywall; Professional installation is recommended.
9. DO NOT use screen in or with ANY type of vehicle or trailer.
10. Immediately remove from service; Any screen with broken or missing parts, torn vinyl, or other visible
damage.
11. USE ONLY WINCO AUTHORIZED REPLACEMENT PARTS.
12. SAVE THESE INSTRUCTIONS for future reference and training.
3400 & 3409
Wall Mounted, Telescopic Screen
CUSTOMER INSTRUCTIONS
Tools needed:
· Phillips-Head Screwdriver
· Scissors or box cutter
· Special tools for mounting to concrete wall (ex. Drill, masonary bit, etc...) it is recommended that someone with
experience using these types of tools perform this type of installation.
· - If using powered tools always wear safety goggles –
MOUNTING BRACKET TO WALL
1. You must first choose a sturdy, unobstructed (clear of ceiling, fans, electrical wiring, etc...) mounting location
approximately 80” from floor to top of Mounting Bracket.
IMPORTANT: Mounting to drywall only is NOT recommended.
2. If mounting to a wall with a solid wood backer-board; Use all four (4) Phillips screws provided; DO NOT
OVERTIGHTEN.
3. If mounting to a cement or concrete-block wall use toggle bolts or appropriate concrete anchors – capable of at
least 30 lbs. holding strength.
4. Install (4) screws – through holes in bracket and into wall – tighten securely & snap on plastic cover.
SEE PHOTOS – NEXT PAGE
PLEASE READ AND FAMILIARIZE YOURSELF WITH ALL INSTRUCTIONS BEFORE PROCEEDING WITH ASSEMBLY
PLEASE READ AND FAMILIARIZE YOURSELF WITH ALL INSTRUCTIONS BEFORE USING THIS PRODUCT.
If you have trouble understanding these instructions contact your dealer or Winco customer support, (800) 237-3377,
e-mail: [email protected] before attempting to use this product; otherwise injury may occur.
Winco assumes no responsibility for damage or injury caused by the
improper assembly, installation or use of these products.