Winco Mfg. 8700 - Table with Face Cutout and Armrests - Manual

Page 1 of 4
006055 Rev BB Date 06-06-12 JWC
1. READ AND FOLLOW ALL DIRECTIONS.
2. NEVER stand on table or INJURY MAY OCCUR.
3. NEVER allow user to sleep unattended on table or INJURY MAY OCCUR.
4. NEVER leave an unconscious user unattended on table or INJURY MAY OCCUR.
5. DO NOT use table for transporting user in or with ANY type of vehicle or trailer. Winco tables have not been tested
or approved for use by an occupant in any type of vehicle or trailer.
6. NEVER leave an infant or child unattended on table or INJURY MAY OCCUR.
7. DO NOT allow children to play on or with the table or INJURY MAY OCCUR.
8. DO NOT put hands, feet or clothing into any openings when changing position of user on table. Attendant MUST
confirm that users hands and feet are safe while changing positions or INJURY MAY RESULT.
9. Periodically, recheck tightness of all nuts, bolts and screws.
10. USE ONLY WINCO AUTHORIZED REPLACEMENT PARTS.
11. NEVER EXCEED the recommended weight capacity of 400 lbs. (181.4 kg).
12. SAVE THESE INSTRUCTIONS for future reference and training.
8600-8700
Adjusting Table w/Armrests
CUSTOMER INSTRUCTIONS
Tools needed:
 Phillips-head
screwdriver
 Two (2) 7/16” wrenches (multiple size wrenches included)
 Scissors or box cutter
 Cardboard shipping container (stays under table during assembly to protect upholstery)
 - If using powered tools always start hardware together by hand first & wear safety goggles
SEE “Parts Reference” (pg.3) for visual reference during assembly.
1. After checking your product for any shipping damage, table needs to be upside-down on cardboard or protective
surface. Remove all packing material and hardware that was secured for shipping. Cut tape on corners of box
so that cardboard will lay flat while you assemble table.
Leg Installation
2. Use a 7/16” wrench to remove (4) ¼-20 x 3” Hex-head Bolts from each table frame rail. You will use these
same bolts to install the legs in following steps.
3. Before you align the (2) Welded Leg Assemblies with holes in Table Frame Rails, see parts guide for direction
of angled legs and read below.
PLEASE READ: On the “face-slot-end” of the table:
One end of Face Paper Cutter will need to swing into position on top of the Leg Assembly frame rail bracket
You will need to align the hole in the un-attached end of the Face Paper Cutter with the Leg Assembly hole
and Frame Rail hole.
PLEASE READ AND FAMILIARIZE YOURSELF WITH ALL INSTRUCTIONS BEFORE PROCEEDING WITH ASSEMBLY
PLEASE READ AND FAMILIARIZE YOURSELF WITH ALL INSTRUCTIONS BEFORE USING THIS PRODUCT.
If you have trouble understanding these instructions contact your dealer or Winco customer support, (800) 237-3377
before attempting to use this product; otherwise injury may occur.
8600-8700 Weight Capacity = 400 lbs. (181.4 kg.)
Winco assumes no responsibility for damage or injury caused by improper assembly,
installation, use, or maintenance of these products.