beautypg.com

Occupant operating instructions – Winco Mfg. 6240 - Inverness 24 Hour Treatment Recliner User Manual

Page 13

background image

Copyright 2014, WINCO MFG., LLC

13

OPTIONAL HEAT & MASSAGE OPERATION:

Control is located on the inside of right arm of chair. (Right is determined - as if sitting in the chair)

Heating: (Heating elements are located in the seat & back of chair)

Push HEAT button - See indicator light on switch
3 Lights = High Heat / Bright Light
2 Lights = Medium Heat / Med Light
1 Lights = Low Heat / Dim Light
No Light = HEAT OFF

Allow 5-8 minutes for back and seat to warm to desired setting.
Heat will automatically shut off after approximately 60 minutes. (Timer resets each time switch is pressed)

Massage option: (The massage option uses 4 separate motors located in the backrest of the chair. Two in the lower
backrest, and two in the middle (upper) backrest.

Push MASSAGE button
1X = Lower Back / Low Intensity
2X = Lower Back / High Intensity
3X = Upper & Lower Back / Low Intensity
4X = Upper & Lower Back / High Intensity
5X = Alternating Upper & Lower Back / High Intensity
6X = MASSAGE OFF

Massage will automatically shut off after approximately 15 minutes. (Timer resets each time switch is pressed)

TROUBLESHOOTING:

With system disconnected from power source, use a DAMP CLOTH ONLY to clean switch, wiring or power pack
(located under seat frame).

If there is no heat or massage or flashing light on the switch - check power cord connections to wall outlet AND
connection of power cord to power pack unit under chair.

If switch displays a flashing light; Disconnect from wall, check all accessible wire connectors under chair for
possible loose connections, then re-plug into wall and test again.

If system still does not work contact Winco customer service: 1-800-237-3377.

OCCUPANT OPERATING INSTRUCTIONS

CORD STORAGE:
(Models with Heat-HT or Heat & Massage-HM)

To prevent tripping on cord, damage to cord, damage to recliner, power
cord should be coiled and stored in the "Hook & Loop" fastener provided
BEFORE transporting chair or when heat & massage is not in use.

HEAT

MASSAGE

HEAT ONLY

OR