Wilson Audio WATCH Center Channel Series 1 - Manual (Page 95)

95
S e c t i o n 7 - T r o u b l e s h o o t i n g
One channel is not operating...
Imaging is off-center...
A chronic lack of bass energy...
S
E C T I O N
7 - T
R O U B L E S H O O T I N G
Check the interconnects from source.
Check the connections on the speaker
cables, both at the amplifier and speaker
ends. Watch especially for connectors
touching each other.
Check your connections. When a tweeter
or mid-range driver is not working, or is
out of phase, the imaging will be off.
Double check your connections for red-
to-red and black-to-black.
Play music at a low level and listen to
each driver in each channel. There may
be a driver that is not operating correct-
ly. If there is a driver that is silent,
please go to the “Driver Out” section of
this troubleshooting guide.
Check the input cable connections on the
enclosure. If one channel is out of phase
(connections reversed), bass will be can-
celled. Note: Turn off your amplifier,
and unplug it from the wall.