Wilson Audio WATCH Center Channel Series 1 - Manual (Page 63)

63
tion. This can be achieved by making a bracket that is higher in the back than in
the front. Because the rotation required for the WATCH Center channel depends
on your listening position, speaker mount height, and listening ear height, we are
unable to provide a table with all of the possible combinations. However, we offer
the following rotational suggestions that will bring you very close to the ideal rota-
tion (assuming a 5 foot mounting height).
Listening Distance Required Rotation
5 - 10 feet 25 degrees
10 - 15 feet 15 degrees
15 - 20 feet 10 degrees
S e t u p
The Center Channel has four 3/8”-16 threaded holes on the bottom of the
speaker. These holes can be used to bolt the Center channel to a custom made
bracket (not provided) that is attached to the ceiling. Please see above for the
requirements of this custom bracket. Once the bracket is made and mounted, fol-
low these instructions to bolt the WATCH Center channel to the ceiling as follows:
1. Set the Center channel on the floor.
2. Using provided 3/16” Allen wrench, remove the four setscrews from the
bottom of the Center Channel.
S
E C T I O N
4 - WAT C H C
E N T E R
C
H A N N E L
S
E T U P