Wilson Audio WATCH Center Channel Series 1 - Manual (Page 65)

65
S e c t i o n 4 . 6 - C e n t e r C h a n n e l F i n a l S e t u p
The final setup work needed before fine tuning and other speaker setup is
performed as follows:
• Set the Phase Delay Correction on the tweeter assembly.
• Connect the speaker cables from the amplifier.
P h a s e D e l a y C o r r e c t i o n - S t a n d o r F l o o r M o u n t e d
The phase delay correction is one of the most important elements of the
setup. There are two methods for setting the PDC: one for floor and stand mount-
ed Center channel and one for ceiling or any other custom location. Set up the
PDC as follows:
1. Find your measured listening distance and ear height.
2. In Section 9, locate the table that corresponds to your Center channel
location and front spike combination (i.e. floor mounted center channel
with spike, nut, diode and one spacer).
Note: There is a unique PDC setting for each Center channel location and
front spike combination. Be sure you are reading from the correct table.
3. Read from the table the required offset (1-13).
S
E C T I O N
4 - WAT C H C
E N T E R
C
H A N N E L
S
E T U P