Viconics VTR7300 Installation Manual - Manual (Page 6)

6 | PIR Ready VTR7300 Series-Installation Guide
Network ready
 All Viconics VTR7300 series Terminal Equipment Controllers are designed for
stand-alone operation.
 They can be fully integrated into your choice of automation systems using the
available communication adapter options.
 If required, stand-alone (Network Ready) Terminal Equipment Controllers can be
field retrofitted with the following communication adapters:
o VCM7000V5000W, Terminal Equipment Controller wireless
communication adapter
o VCM7300T5000B, Terminal Equipment Controller BACnet™ MS-TP
communication adapter
T
ERMINAL
, I
DENTIFICATION AND
F
UNCTION
TERMINAL
IDENTIFICATION
ALL VTR73XXA5X00(X)
TERMINAL EQUIPMENT CONTROLLER
Terminal 3 Tx
– Rx Communication
Terminal 4 Power Hot 7.0 VDC
Terminal 5 Power Common
Terminal 13 BI 1 ( Configurable )
Terminal 14 Scom
Terminal 15 BI 2 ( Configurable )
C
OMMUNICATION WIRING TO
VC3
XXX
X R
ELAY
P
ACK
Only ONE VC3xxxX Relay Pack with remote monitoring inputs can be used under a single
VTR73xxA Controller. All other slave units must be VC3xxxX Relay Pack(s) WITHOUT
remote inputs. A maximum of 10 VC3xxxX Relay Packs can be used for a single
VTR73xxA Terminal Equipment Controller.