Viconics VTR7300 Installation Manual User Manual
Page 18
18 | PIR Ready VTR7300 Series-Installation Guide
%RH disp
Local %RH Display
Default value = Off
Models with Humidity
sensor only
Conditional parameter to Humidity models
VTR735xX5x00(X)
Enables the display of humidity value below the room
temperature value on the display
On = Display %RH
Off = No display of %RH
Lockout
Keypad lockout levels
Default value = 0 No lock
USER KEY FUNCTIONS
LEVEL
0
1
2
3
4
5
PulsedHt
VDC output configuration
Default Value = Off
VDC output configuration. VC3000 series model dependent
Off = Regular On-Off control for VC350xE models only
Can be used with 2 & 4 pipes applications
On = VDC SSR electric heat 10 second pulsed time
base modulation for VC340xE models only
Can only be used with 2 pipes system only.
Occ Out = VDC Occupancy output follows local device
occupancy for VC3514E model only.
Occupied & Temporary Occupied = Contact closed
Stand-By & Unoccupied = Contact opened
Pipe No
System type installation
Number of pipes
Default is: 4.0 Pipes
Defines the type of system installed
2.0 Pipes, will limit the number of sequences of operation
available from 0 to 4
Will enable heat/cool operation from the same output
4.0 Pipes, can access all the sequences of operation from
0 to 2
Will enable heat/cool operation from different output