Viconics VT7600F Installation Manual - Manual (Page 20)

20 | PIR Ready VT7600 Series-Installation Guide
Channel
Channel selection
Default value = 10
Range is: 10 to 26 Conditional parameter to Wireless models
(VT76xxX5x00W)
This parameter will only appear when a wireless
network adapter is present. If the Terminal Equipment
Controller is installed as a stand-alone
(Network
Ready) unit or with a
BACnet™ or Echelon™ adapter,
this parameter will not be used or displayed
This parameter (Channel) is used to link specific
Terminal Equipment Controllers to specific Viconics
wireless gateway(s) (VWG) For every Terminal
Equipment Controller reporting to a gateway
(maximum of 30 Terminal Equipment Controllers per
gateway), be sure you set the SAME channel value
both at the gateway and the Terminal Equipment
Controller(s).
Viconics recommends using only the usage of
channels 15 and 25 only.
The default value of 10 is NOT a valid channel. The
valid range of available channel is from 11 to 26