Viconics VT8600 Series BACnet Integration Guide - Manual (Page 4)

VT8600 Series BACnet ® Integration Manual 4
Viconics Technologies Inc. | 9245 Langelier Blvd. | St.-Leonard | Quebec | Canada | H1P 3K9 | Tel: (514) 321-5660 | Fax: (514) 321-4150
028-0437-00 www.viconics.com | [email protected] March 2015
©
2
01
5 V
ic
onic
s T
ec
hno
lo
gi
es
Inc
. A
ll r
ig
ht
s r
ese
rv
ed
.
Object Type
Read/Write Settings
Object Property Controller Parameter
Input
AI
Output
AO
Values
AV
Read Only Read Only Read Only
Event State
Property 36 Indicates if object has an active event state associated
with it
Read Only Read Only Read Only
Object Identifier
Property 75
Unique ID number of an object on a network
Read Only Read Only Read Only
Object Name
Property 77
Unique name of an object on a network
Read Only Read Only Read Only
Object Type
Property 79
Indicates membership in a particular object type class
Read / Write Read / Write Read / Write
Out of Service
Property 81 Indicates whether (TRUE/FALSE) the physical input
object represents is not in service
Read / Write* Read / Write Read / Write
Present Value
Property 85
Contains values of all properties specified
N/A Read Only Read Only
Priority Array
Property 87
Read-only array of prioritized values
Read Only Read Only Read Only
Reliability
Property 103
Indicates if Present_Value is "reliable"
N/A Read Only Read / Write †
Relinquish Default
Property 104 Default value used for Present_Value when values in
Priority_Array have a NULL value
Read Only Read Only Read Only
Status Flags
Property 111 Represents flags that indicate general health of life
safety point object
Read Only Read Only Read Only
Units
Property 177
Indicates measurement units of Present_Value
N/A Read Only N/A
Hight Limit
Property 1101 Specifies a limit Present_Value must exceed before an
event is generated
N/A Read Only N/A
Low Limit
Property 1100 Specifies a limit Present_Value must fall below before
an event is generated
N/A = Not Applicable, property not used for objects of that type
* The Present_Value is only writeable when Out_Of_Service is TRUE.
† Relinquish default is Read Only for AV100+
ANALOG OBJECT PROPERTIES