Casio EX-P505 - Manual (Page 72)

BASIC IMAGE RECORDING
72
Flash Unit Status
You can find out the current flash unit status by pressing
the shutter button half way and checking the monitor
screen and operation lamp.
* Operation lamp
It means this:
Flash unit is charging
Flash unit is ready to fire
When the operation
lamp is doing this:
Flashing red
Lit red
Operation lamp *
The indicator is also shown on the
monitor screen when the flash unit is
ready to fire.
Changing the Flash Intensity Setting
Perform the following steps to change the flash intensity
setting.
1. In a REC mode, press [MENU].
2. Use [ ̇] and [̈] to select the “REC” tab.
3. Use [
̆] and [̄] to select “Flash Intensity”,
and then press [
̈].
4. Use [
̆] and [̄] to select the setting you
want, and then press [SET].
IMPORTANT!
• Flash intensity may not change if the subject is too
far or too close to the camera.
To make flash intensity:
Stronger
Normal
Weaker
Select this setting:
+2
+1
0
–1
–2