Toa C-PH200 - Manual (Page 9)

9
1. Remove bushing plate fixing screws (4 pieces) to pull out
the terminal chassis that is integral with the bushing plate.
2. Install the control input and coaxial cables by routing both
cables through the bushing.
Bushing plate fixing screw (4 pieces)
Control input cable
Bushing
Control input cable
Bushing
Bushing plate
Coaxial cable
Rubber packing ring
(Mount securely)
5.4. Control Input Cable and Coaxial Cable Connections
Note
• Be sure to mount a rubber packing ring when routing the control input and coaxial cables through the
bushing.
• If a gap is created between cable and bushing, wrap the self-adhesive butyl rubber tape around the cable to
prevent the entry of rainwater.
• Ensure the routed cable is correctly fixed by lightly pulling it.