Toa C-PH200 - Manual (Page 3)

1. SAFETY PRECAUTIONS
• Be sure to read the instructions in this manual section carefully before use.
• Make sure to observe the instructions in this section as the conventions of safety symbols and messages
regarded as very important are included.
• Please keep this instruction manual handy for future reference.
Safety Symbol and Message Conventions
Safety symbols and messages described below are used in this manual to prevent bodily injury and property
damage which could result from mishandling. Before operating your equipment, read this manual first so you
are thoroughly aware of the potential safety hazards as well as understand the safety symbols and messages.
3
Indicates a potentially hazardous situation which could result in death
or serious personal injury if ignored or mishandled. WARNING
When Installing the Pan/Tilt Head
• Use the unit only with the voltage specified on the unit. Using a voltage higher than that which is specified
may result in fire or electric shock.
• To prevent lightning strikes, install the unit at least 5 meters away from a lightning conductor yet within the
protective range (angle of under 45 degrees) of the lightning conductor. Lightning may cause a fire, electric
shock or personal injury.
• Leave the installation of the unit to your TOA dealer because the installation requires expert knowledge. If an
inexperienced installer installs the unit, the unit may fall, possibly causing personal injury.
• Install the unit only in a location that can structurally support the weight of the unit and the mounting bracket.
Doing otherwise may result in the unit falling and causing personal injury.
• Avoid installing the unit in vibratory locations. Mounting screws and bolts loosen, which causes the unit to fall
off, possibly resulting in personal injury.
• When installing the unit in snowy areas, take appropriate measures to protect the unit against snow. The
accumulation of snow causes the unit to fall off, possibly resulting in personal injury.
• Be sure to install the unit with two or more persons. If it is handled by a single person, the unit may fall or
topple over, causing personal injury.
• Install the unit only with the specified method. Failure to follow this instruction may cause extreme force to
be applied to the unit and the unit to fall, resulting in personal injury.