Toa HY-CN7W-WP - Manual (Page 2)

2
HY-CN7B, HY-CN7W, HY-CN7B-WP and HY-CN7W-WP Speaker Connection Brackets
HX-7 Series speaker
Side angle plate of Speaker
Connection Bracket
Rear angle bar of Speaker
Connection Bracket
Use the brackets to join.
First speaker Second speaker
Protection cover Speaker molule A Speaker molule B
2. GeNerAL DeScrIpTION
The HY-CN7 Series brackets are used to join together two HX-7 Series speaker systems into a single system.
Joining speakers together not only allows more accurate control of directivity for lower frequencies, but also
enhances the audibility of amplified speech in locations that suffer from long reverberation times or high
background noise levels. The HY-CN7B and HY-CN7W brackets are designed for indoor installations, and the
HY-CN7B-WP and HY-CN7W-WP brackets are for outdoor installations under eaves or other areas protected
from direct exposure to the elements.
3. cOMpLeTe ASSeMbLY
4. cONNecTING TWO SpeAker SYSTeMS
Before connecting speaker systems, lay out a protective sheet, corrugated cardboard or other soft material on a
flat surface, and perform all work on the 2 speakers with their front baffles facing downward. It is recommended
that at least two persons be involved in the connection work.
Two speaker systems can be joined together by connecting speaker modules (A and B in the figure below)
using the specified bracket hardware.
Note: Position speaker modules A and B facing in the same direction. In the figure, their side angle plate
protection covers are visible on the left side of each speaker system.
Do not join together 3 or more HX-7 Series Speaker Systems. Doing so
may cause the speaker systems to fall off, resulting in personal injury.
WArNING
(Joining together two HY-7 Series Speaker Systems)