Tii SVM-1R-P User Manual
Description, Features, Installation

P/N 92225601 • Rev B• 7/9/2008
Warranty: If this unit fails during the warranty period, contact tii customer service to authorize return. Unit may be returned prepaid.
Model SVM-1R-P
Indoor Switchable Voice Module
Installation Note
Description
1.
The tii SVM-1R-P (Switchable Voice Module) is a
microprocessor controlled module that provides seamless
switching from Telco to VoIP service in multiple dwelling
units (MDU’s).
The tii SVM-1R-P is for indoor use only.
Features
Figure 1
Installation
1.
Remove the unit from the bag and inspect it for damage. If
damaged, obtain another unit.
2.
Locate a suitable flat, dry area to install the unit.
3.
The SVM-1R-P should be located near the first
appearance of the Telco and VoIP Phone. The SVM-1R-P
is supplied with double faced tape for secure installation.
Figure 2
Wiring
House Phone
1.
Plug one end of the RJ-11 cable to the Local/Aux. Phone
receptacle on the SVM-1R-P. Plug the other end to the
p
hone at location (Figure’s 2 & 4).
Digital Phone Modem
2.
Plug one end of another RJ-11 cable to the digital phone
modem receptacle on the SVM-1R-P. Plug the other end
to the RJ-11 output from MTA/EMTA of cable modem
(Figures 2 & 4)
Telco
3.
Plug on end of the RJ-11 cable to the Telco Input
receptacle on the SVM-1R-P (Figures 2 & 4).
4.
Wire the other end of the cable to the Telco input and
other phone connections in multiple dwelling units.
VoIP
From
MTA/EMT
A
Phone at
location
3
2
3
2
Telco
Input
3
2