Tii 79 Series User Manual
Tii Equipment
TII P/N 92225101
141 Rodeo Drive
tii 78 / 79 Series
Edgewood, NY 11717
Dual Service Provider Switch
Customer Service/Sales 888-844-4720
02/08 Rev B
INSTALLATION
NOTE
1. GENERAL DESCRIPTION
1.1 The TII 78 and 79 Series are designed for
applications requiring more than one service provider
which requires a connection to a single tip-ring pair. It
offers one or more outputs for the customer premises
telephone wire termination.
2. WARRANTY
2.1 See TII Warranty. If this unit fails during the
warranty period, the factory should be requested to
authorize return. Return the unit prepaid. Units that fail
due to normal wear or abuse should be discarded.
3. INSTALLATION
3.1 Remove the Dual Service Provider Switch
from plastic bag and inspect; if damaged, replace with
an undamaged switch.
3.2 Installation is accomplished using standard
technician tools. The Insulation Displacement
Contacts (IDC) are achieved using gel sealed
rockers.
3.3 IDC Terminations accept 26-22 AWG solid wire.
3.4 Locate a suitable flat, dry area to install the unit.
Use a size #8 screw to mount the unit. Install the TII
78 Series Termination Block. See Figure 1.
3.5 The 78 switch can be installed within an indoor /
outdoor listed housing. Use suitable hardware to
attach the block to the mounting service.
3.6 The 79 switch mounts in the customer
compartment of a TII 5100 NID. See Figure 2.
3.7 Lower the 79 switch into the 5100 NID and align
the locating fingers with the locating slots. Press down
until unit locks into locking tab. See Figure 3.
4. WIRING
4.1 Provides three pair customer wire terminations
with very low insertion loss from input to output.
Do not strip wire insulation from wires to be
terminated to Switch.
NOTE: IDC’s accept 22-26 AWG solid wire. Wires
should be aligned to the corresponding holes.
Green wire to the “T” (GRN) labeled wire guide
and the Red wire to the “R” (RED) labeled wire
guide.
TII 78
FIGURE 1
Wire Loom
Test Points
Customer Wire Telco
Output Terminations
Digital Voice
Service Input
RJ-11 Interface
Tip (Green)
Ring (Red)
3 Pair Telco Input
MTA Input
Mounting Hole
TII 79
TII 78 Wiring