Tii 95-1-00-1 User Manual
Page 2
3. Insure excess wire ends are wrapped tightly
around screw. Tighten screws snugly. Tuck
excess wire in trough. Additional wires should
be coiled and stored in trough. Perform
customary tests. Close and snap cover
securely. (NOTE: Use a Master
®
Lock #10 or
equivalent (sold in local stores) when it is
desirable to lock individual covers.)
Testing
CAUTION: INSERT A PLUG INTO TEST
JACK PRIOR TO ANY WIRING CHANGES.
1. Plug a working phone directly into the test
jack. WAIT ONE MINUTE. Lift receiver. If
problem goes away, fault is in customer wiring
or equipment. If not, call telephone company.
Disconnect plug from jack, close cover.
See also other documents in the category Tii Equipment:
- OF025PFNOPNST1 (2 pages)
- IF025PFNOPNST1 (2 pages)
- 210 (2 pages)
- 220 (1 page)
- 231-2 (1 page)
- 68T-2S-4 (1 page)
- 68M-2-1T (1 page)
- 68M-12-1T (1 page)
- 68M-1-1T (1 page)
- 170-06-03 (2 pages)
- 69T (1 page)
- ISB (2 pages)
- ISB-MB (1 page)
- 372S-12LP (1 page)
- 372S-12 (1 page)
- 80-100 (1 page)
- 80-400 (1 page)
- 80-410V-45 (1 page)
- SCT-A (1 page)
- 87 (1 page)
- 95S Series (2 pages)
- 95S Series (3 pages)
- 96-00-1 SERIES (2 pages)
- 96-00-4 SERIES (2 pages)
- 97 (2 pages)
- 97C (1 page)
- 99S SERIES (2 pages)
- 831E (1 page)
- 831W2 (1 page)
- 856E (1 page)
- VIS-4 (2 pages)
- ONT-SS (1 page)
- VIS-2 (2 pages)
- FDT1 Series (2 pages)
- FDT2 Series (2 pages)
- FDH1 (14 pages)
- 169F SERIES (2 pages)
- 506F (2 pages)
- 506F-03 (2 pages)
- 506F-02-01-04 (2 pages)
- 506F-01-01-01/-02/-03 (2 pages)
- UVS-12 (1 page)
- 761-4T-12 (2 pages)
- VIS-3 (2 pages)
- FET1 Series (2 pages)