TeeJet FieldPilot Install John Deere 4x40, 4X50 & 4X55 - Manual (Page 19)

www.teejet.com
18
FieldPilot ®
14. iNstallatioN oF eNgage/diseNgage switCh
Connect item (A) to the connector on the SCM harness labeled Remote Engage/Disengage. Install the push
button in a location that is easily accessible during operation of the machine. This switch (A) is not required
if the optional foot switch 32-04020 is used.
Figure 1-14: Engage/Disengage Switch
15. reCoMMeNded eleCtroNiCs iNstallatioN
The Steering Control Module (SCM) should be mounted securely to the floor of the cab. A good location
is to the right of the seat near the rear of the cab. The control console can be mounted to the operator’s
preference. The GPS antenna should be mounted as far forward as possible on top of the cab on a metal
surface of at least 4” square.
Figure 1-15: Recommended Electronics Installation
GPs