TeeJet 814-AB Airblast Sprayer Monitor - Manual (Page 3)

814-AB Sprayer Monitor Programming and Operating Manual US 9/98 Page 3 of 15
Programming Guidelines
Make sure that all hardware components are properly installed and tested. Before you start
the programming process you should first check if the console and all sensors are working
properly.
Important Preliminary Information
Before you begin, we recommend that you review the following Programming Guidelines that
control the programming process:
☛
The Pro key is used for power ON
☛
Clr & Down key combination is used to power OFF (when not spraying)
☛
Holding Pro key for 3 seconds is used to enter and/or exit the programming mode
☛
Shortly pressing the Pro key once while in the programming mode saves the current
parameter and advances to the next programming step
☛
Shortly pressing the Clr key restores the parameter with the default value
☛
Holding the Clr key restores the parameter with its minimum value (mostly zero)
☛
The value of a parameter is changed with the Up and Down keys. Holding the Up or
Down key changes the parameter rapidly.
☛
Pressing the Pro key once while displaying the working width will allow the working width
to be adjusted. Once adjusted, pressing the Pro key again will return to the normal
operating mode.