TeeJet 814-AB Airblast Sprayer Monitor - Manual (Page 13)

814-AB Sprayer Monitor Programming and Operating Manual US 9/98 Page 13 of 15
☛
While spraying with the Master switch “ON”, you can scroll through the different displays
until the information you want is on the display :
♦ actual working width in FT(m)
♦ actual application rate in GPA (l/ha)
♦ vehicle speed in MPH (km/h)
♦ pressure in PSI (bar)
♦ application area covered in Acres (hectares)
♦ total volume applied in Gallons (liters)
☛
Adjust the pressure and target application rate with the +/- switch.
As you enter the field to the point where you will begin spraying, turn the Master switch to
“ON” position. This will activate the spraying operation. Maintain your usual vehicle speed for
spraying. Use the +/- key to maintain the application rate.
If for any reason you need to stop, turn the MASTER SWITCH to “OFF.”
Sensor Monitors
Speed, Flow and Pressure sensor monitors are located just above the monitor display. Each
time a sensor receives a pulse, the appropriate sensor LED will flash or turn on. The LED
display indicates which components are sending signals to the console. The LED's will be
green when the console receives a signal from the sensored components. If a system
malfunction occurs, check the sensor monitors to be sure that the LED displays are lit for the
components being used. If one is not, you will know that a problem exists with the
transmission or receipt of the signal associated with the component.
Automatic Power Down
The Sprayer Monitor Console has an automatic power down feature. With the Master switch
in the “OFF” position, the Console will automatically shut down after 10 minutes of no inputs
(when in normal monitor mode). This prevents possible battery drainage.
You can also power down the controller by the following key combination: press
simultaneously the Clr and Down keys and the console will power down immediately (only
with Master switch OFF).
W
ARNING
: D
O NOT SWITCH OFF THE CONSOLE BY REMOVING THE MAIN CABLE
!