TeeJet 814-AB Airblast Sprayer Monitor - Manual (Page 10)

814-AB Sprayer Monitor Programming and Operating Manual US 9/98 Page 10 of 15
Only right hand side is active:
5.0 ft O->
Press the Up or Down key to select another display.
Changing the Working Width
The working width (distance between the trees) can quickly be changed by pressing the Pro
key when the width is displayed. The following screen will be shown:
> 10.0 ft <--->
The width number will be flashing and can now be changed with the Up and Down keys.
Pressing Pro again after the value is entered will save the new working width and the console
returns to the steady working width screen.
S
PEED AND
A
PPLICATION
R
ATE
The next monitor display is the speed and application rate display. On the left the current
speed is shown in MPH (km/h) and on the right hand side the current dose rate in GPA (l/ha)
is shown. When the Master switch is switched off, the application rate shown is zero.
5.0 mph 50 Gpa
Press the Up or Down key to select another display.
A
PPLICATION
R
ATE AND
P
RESSURE
In this display the application rate in GPA (l/ha) and the pressure in PSI (bar) are shown.
The pressure is only shown when there is a pressure sensor installed.
20 Gpa 30 PSI
Press the Up or Down key to select another display.
F
LOW
R
ATE AND
P
RESSURE
In this display flow in GPM (l/min) and the pressure in PSI (bar) is shown. The pressure are
only shown when there is a pressure sensor installed.
10.2 GPM 25 PSI
Press the Up or Down key to select another display.