TeeJet 500 SLURRY COMPUTER - Manual (Page 26)

N OTES T EE J ET 500 S LURRY COMPUTER OPERATORS MANUAL
26
SOFTWARE INFO
The current operating software version number for the TeeJet 500 Slurry computer
can be seen.
TEST
TEST INPUT
Test input can be used if a sensor is suspected defect
Directly under each input description, to the right, is a counter that registers the
number of time the input has been activated (the counter is reset automatically
each time “Test input” is exited or by pressing the C key). On the left-hand side
the actual status of the input is shown (Hi/Lo).
All of the different inputs can been seen by pressing the ARROW UP and ARROW
DOWN keys to page through the 3 screens.
The different input descriptions relate to the following:
Input Description
Wheel
Forward speed signal from the sensor fitted on the tractor
(via the 7-pin DIN/ISO socket fitted in the tractor).
Radar
Forward speed signal from the radar fitted on the tractor
(via the 7-pin DIN/ISO socket fitted in the tractor).
Wheel
implement
Forward speed signal from the sensor fitted on the slurry spreader.
Press the ARROW DOWN key to see the next inputs:
PTO
Rpm signal from the sensor fitted to the PTO shaft.
Flow
Signal from the flow meter.
Press the ARROW DOWN key to see the next inputs:
Rpm pump Rpm signal from the sensor fitted to the pump.
Rpm
distributor Rpm signal from the sensor fitted to the distributor.
Implement
Implement signal (area ON/OFF) from the implement sensor fitted
to the tractor (via the 7-pin DIN/ISO socket fitted in the tractor).
TEST OUTPUT
Each individual output can be tested. Press the program key number for the
following test:
Output Description
Rate +
Program key 1 opens the regulation unit.
Rate -
Program key 2 shuts the regulation unit.