TeeJet Sentry 6140 - Manual (Page 13)

11
98-05306-ENUS R2
Sentry 6140 Tip Flow Monitor
number of Sections
Select the number of boom sections. The sections are numbered
from left to right while standing in the forward facing direction of
the machine and begin at the Start Terminator. Range is 1 to 15
sections.
1. Press the MINUS/PLUS buttons
to adjust the number of
boom sections.
2. Press
►NEXT PAGE button to proceed to Number of Tips per
Section.
►PREVIOUS PAGE button to go back to Tip Alarm Delay.
Figure 20: Number of Sections
number of tips per Section
Enter the number of tips on each boom section.
Sections are numbered from left to right while
standing in the forward facing direction of the machine and begin at the
Start Terminator. Range is 1 to 120 tips.
1. Press the MINUS/PLUS buttons
to set the number of tips
per the current section.
2. At the boom section 1, press
►PREVIOUS PAGE button to go back to Number of Sections.
►NEXT PAGE button to cycle through all available boom
sections.
3. At the last boom section, press
►NEXT PAGE button to proceed to Boom Section On/Off
Beep.
►PREVIOUS PAGE button to go back to previous boom
sections.
Figure 21: Tips per Section
Boom Section on/off Beep
Enable/disable beep when a boom section is turned on or off.
This feature is useful if a BoomPilot system frequently
changes boom sections.
1. Press the UP/DOWN buttons
to toggle the mute function
on or off.
2. Press
►NEXT PAGE button to proceed to Display Brightness.
►PREVIOUS PAGE button to go back to last boom section of
the Number of Tips per Section setup.
Figure 22: Boom Section Beep – ON