TeeJet Sentry 6140 - Manual (Page 11)

9
98-05306-ENUS R2
Sentry 6140 Tip Flow Monitor
SetUp
If there are questions concerning the setup of the Sentry 6140,
please contact your dealer or TeeJet Customer service
representative for clarification before operation. TeeJet Technologies is
not responsible for misuse or incorrect operation of the system.
Setup is used to configure Display Brightness, Master Sound, Tip Alarm
Percentage, Tip Alarm Delay, Number of Sections, Number of Tips per
Section and Boom Section On/Off Beep.
Figure 13: Setup Button on Home Screen
Figure 14: Buttons on Setup Screens
Previous
Page
Next
Page
Home
Screen
Figure 15: Setup Screen Order
◄ Display Brightness – Sets the
brightness level of the display
◄ Master Sound – Enable/disable
console sound
◄ Tip Alarm Percentage – Sets
the error reporting range for the
tip sensors
◄ Tip Alarm Delay – Sets the time
the console will wait after an
error has been encountered
before sounding a tip alarm
◄ Number of Sections – Sets the
number of boom sections
◄ Number of Tips per Section –
Enters the number of tips on
each boom section
◄ Boom Section On/Off Beep –
Enable/disable beep when a
boom section is turned on or off