SUUNTO FAVOR S - Manual (Page 26)

26
3.3 DIVING
3.3.1 Basic Dive Data
The dive computer will remain in the SURFACE mode at depths less than 1.2 m
[4 ft]. At depths greater than 1.2 m the instrument will go into the DIVE mode.
Each piece of information on the display is clearly marked (Fig. 3.8). During a no-
decompression dive, the following information will be shown:
• the available no-decompression time (a) in minutes is shown as NO DEC
TIME. It is calculated based on the five factors listed in Section 6.1,
“OPERATING PRINCIPLES”.
• your present depth (d) is shown in meters [ft].
• the elapsed dive time (f) in minutes in the lower right corner, shown as
DIVE TIME.
• the personal/ altitude adjustment (e) setting (A0, A1, or A2).
In the lower left corner the following information will alternate:
• the maximum depth during this dive (b) in meters [ft], indicated as MAX,
for about 5 seconds.
• the water temperature (c), with °C for Centigrade [or °F for Fahrenheit], for
about 3 second.
Fig. 3.8 DIVING DISPLAY
The present depth is 19.3 m [63 ft] (d),
the no-decompression time limit is 23
minutes (a) in A1 mode (e) and the dive
time is 6 minutes (f). Maximum depth
during this dive 29.8 m [98 ft] (b) and
water temperature 18°C [64°F] (c) are
alternating in the lower left corner.