StarTech.com SV1115IPEXEU - Manual (Page 9)

Instruction Manual
5
Follow these instructions if the host computer uses a USB keyboard and mouse:
IMPORTANT: Not all computers fully support USB mice and keyboards and recognize
them on startup. It is strongly recommended that you test the USB devices you will
use with the host computer before configuring the SV1115IPEXT. If the computer does
not work properly with USB devices, you can attempt to update the computer’s BIOS
to the most recent version to see if it adds USB input device functionality. Consult your
computer manufacturer for details.
1. Power down the computer to which the SV1115IPEXT will be connected (host
computer). If purchased, install the unit in your rack or cabinet following the
instructions that came with the 1110EXTRACK (optional, not included).
2. If present, disconnect the existing monitor and USB keyboard/mouse from the host computer.
3. Using the provided integrated KVM cable, locate the end with the male VGA
(monitor) connector and connect it to the VGA-out connector on the back of the
host computer.
4. Insert the female VGA connector on the opposite end of the integrated KVM cable
to the Video (IN) port on the rear panel of the SV1115IPEXT.
5. Connect a USB Type A to B cable to the USB port on the rear panel of the KVM.
6. Connect the opposite end of the USB Type A to B cable to an available USB port on
the managed computer.
7. Using a Category 5 Ethernet patch cable, connect the LAN connector on the rear
panel of the SV1115IPEXT to a network data jack (usually on a hub, switch, router, or
pre-wired wall jack).
8. Optional: If needed, connect the WAN connector on the rear panel of the SV1115IPEXT
to a network data jack (usually a hub, switch, router, or pre-wired wall jack).
9. Important: If you want to continue to use the host computer locally, skip step 11
and go directly to Connecting a Local Keyboard, Mouse, and Monitor (next page)
after completing step 10. Otherwise, complete step 11 now and continue to the
section entitled Configuring SV1115IPEXT
10. Connect the power cord (provided) to an appropriate electrical outlet, plug
the opposite end of the power cord into the AC/DC adapter, and plug the power
connector into either the DC-in or DC-in-2 ports on the rear panel of the unit. The
LED underneath the power connectors will be solid green when the unit is powered.
11. Power on the host computer..