StarTech.com SV1115IPEXEU - Manual (Page 45)

Instruction Manual
41
Configuring IPMI on the SV1115IPEXT
Once you have connected the IPMI-configured serial port to the SV1115IPEXT and
enabled the software option, you can begin to configure IPMI settings through the
Web interface. Log in to the Web interface as admin.
Click the Admin/Setup link at the top of the page and choose IPMI/IPMB setup
(Intelligent Platform Management).
You will be presented with the IPMI Status menu. Make the following changes to
enable IPMI:
• Enable IPMI (Intelligent Platform Management Interface via serial port: select Enabled.
• Select which serial port to use: select either Front serial port (DTE pin out) or Rear
serial port (DCE pin out) based on how the SV1115IPEXT is connected to the IPMI
serial port on the host computer.
• Select baud rate to use: select a value from the menu between 9600 bps and
115,200 bps based on the configuration on the host computer’s IPMI settings.
• BMC Password: Enter the password twice assigned to the BMC in the host
computer’s BIOS setup software.