Configuring the remote connection – StarTech.com SV1115IPEXEU User Manual
Page 51
Instruction Manual
47
Configuring the Remote Connection
This section describes how to configure a typical Windows dial-up session to access the
modem connection on the SV1115IPEXT. The instructions here relate to a Windows XP
configuration; other versions of Windows are similar.
1. Open My Network Places from the desktop or the Start menu.
2. Click View network connections.
3. Click Create a new connection under Network Tasks.
4. The New Connection Wizard window will open. Click Next.
5. Select Connect to the Internet and click Next.
6. Select Set up my connection manually and click Next.
7. Select Connect using a dial-up modem and click Next.
8. In the space provided under ISP Name, type an appropriate name of your choosing
for the connection. Click Next.
9. In the space provided under Phone Number enter the phone number for the line to
which the SV1115IPEXT’s modem is connected. You may need to add the area code,
country code, or other digits needed to access the outside line as appropriate. When
finished, click Next.
10. Make your choice from Anyone’s use or My use only and click Next.
11. Beside User name enter the user name of any valid user created using the Web
interface of the SV1115IPEXT. Beside Password and Confirm password enter the
password that the user you entered above uses to access the Web interface.
12. This screen also includes 3 checkboxes. Uncheck all 3 checkboxes.
13. Click Next.
14. You may select to add a shortcut to the desktop for this connection. Click Finish.
• PPP (Point-to-Point Protocol) must be used; no other authentication methods
are supported.
• TCP/IP must be installed/enabled on the computer making the connection,
and must be used for the dial-up connection.
• The connection must be configured to obtain a dynamic IP address.
• The user name/password must match a user currently configured on the
SV1115IPEXT.
• For best performance and to simplify the troubleshooting process, firewall
software should not be used with the dial-up connection.