SilentKnight IPGSM-4G - Manual (Page 13)

IPGSM-4G Commercial Fire Communicator – Installation and Setup Guide
– 11 –
RF Specifications
Frequency Bands
2G
GSM/GPRS/EDGE Quad Band, 850/900/1800/1900 MHz
3G/4G UMTS/HSPA+ Band V, Band II
Output Power
2G
GPRS +33dBm, GMSK modulation
EDGE +27dBm, 8-PSK modulation
3G UMTS +24dBm, QPSK modulation
WCDMA +24dBm, QPSK modulation
4G HSPA+ +24dBm, 64 QAM modulation
WCDMA +24dBm, 64 QAM modulation
Central Station Messages
Alarm Condition Alarm Code Restore Code
Power On / Reset E339 C0803 N/A
ECP Supervision (Compromise Indication) E355 C0000 R355 C0000
Primary Communication Path Supervision E350 C0951 R350 C0951
Secondary Communication Path Supervision E350 C0952 R350 C0952
Periodic GSM Comm Path Test Failure
(We do not send a restoral R358 C0803, we send a failure message every day
after the radio attempts to test and fails.)
E358 C0803 N/A
Trouble Reporting:
When a single fault (open or short IP, GSM suppression, low/missing battery,
AC loss) occurs, and the communicator is programmed for an IP& GSM com-
munication path, multiple alarm Codes and their appropriate Restore Codes
are reported to the Central Station.
IPGSM-4G communicator fault – The Fire Panel sends out a E380, and E352
message via Telco #1, these are then relayed to the central station via the
IPGSM-4G.
Telco line 1 fault – The Fire Panel sends out a E380, and E351 message via
Telco #2, these are then relayed to the central station via the IPGSM-4G.
Telco line 2 fault - - Fire Panel sends out a E380, and E352 via Telco #1, the-
se are then relayed to the central station via the IPGSM-4G.
E380, E351,
E352 codes as
appropriate.
N/A
Test 5555 5555 9 N/A
AlarmNet Messages
Communication failure.
(Possible Compromise Indication)
5555 1555 6 5555 3555 6
Authorized Radio Substitution 00D0 010C 0 N/A
Unauthorized Radio Substitution Attempt 00D0 010E 0 N/A
Service Termination 00D0 020E 0 N/A