Shellab SRI20P - Manual (Page 6)

6 | P a g e
RECEIVING YOUR INCUBATOR
Before leaving the factory, all incubators are packaged in high-quality shipping materials to provide
protection from transportation-related damage.
When an incubator leaves the factory, safe delivery becomes the responsibility of the carrier. Damage
sustained during transit is not covered by the warranty.
When you receive your incubator, inspect it for concealed loss or damage to its interior and exterior. If
you find any damage to the incubator, then
follow the carrier’s procedure for claiming damage or loss.
I
NSPECTING THE
S
HIPMENT
Carefully inspect the shipping carton for damage. Report any damage to the carrier service that delivered
the incubator. If the carton is not damaged, open the carton and remove the contents.
Verify that the correct number of shelves, shelf slides, and leveling feet have been included (see the
following table for quantities).
Included accessories
Model Standard Shelves Sliding Shelves Leveling Feet
SRI3P 2 0 4
SRI6P 2 0 4
SRI20P 4 1 4
Model Side Air Ducts
SRI3P 0
SRI6P 0
SRI20P 2
Carefully check all packaging before discarding. Save the shipping carton until you are sure everything
works properly.
R ETURNING THE S HIPMENT
If you must return the incubator for any reason, first contact your service representative for a return of
material authorization (RMA). You must provide the
unit’s data plate information. See Recording Data
Plate Information below.