beautypg.com

Operation, 6 operation – SeaLand 4700 Series VacuFlush Operation Manual User Manual

Page 7

background image

7

SeaLand 4700 Series VacuFlush Toilet

Specifications

6 Operation

6.1

Toilet system start-up

1 . Fill freshwater tank .
2 . Turn on electrical power and water supply to toilet .
3 . Flush water through toilet system by flushing toilet five times (allow each flush cycle to complete

until green light indicates system is ready for next flush) . Each cycle takes about one minute .

6.2

Normal toilet operation

ADD WATER TO TOILET BOWL

Press “Add Water” switch or raise flush handle (depending
on toilet model) until desired water level is achieved . More
water is usually added only when flushing solids . (If switch
is pressed too long, water flow will shut off automatically to
avoid overflow .)
BACKLIGHTING: To turn switch panel backlighting effect off
or on, push “Add Water” switch twice very quickly .

FLUSH TOILET

Press “Flush” switch or press flush handle down (depending
on toilet model) for a moment, then release it . Flush only when
the green “OK to Flush” light is on . Toilet will not flush until the
green light is on . After flushing, it takes about one minute for
vacuum to recharge for the next flush .
If the red “Do Not Flush” light is on, the system is either
recharging the vacuum, or the holding tank is full . The toilet
will not flush while the red light is on .

DO NOT FLUSH FOREIGN OBJECTS

CAUTION! Flush only water, bodily wastes and rapid-dissolving tissue paper . Do not
flush wet wipes, sanitary napkins, condoms, diapers, razor blades paper cups, cotton
swabs food, hair or liquids such as oils or solvents . Clogging or damage to the toilet
system may occur .

Note
Make sure all guests understand toilet operation before use.

6.3

Changing flush modes

SeaLand 4700 series VacuFlush toilets offer two flush settings to help manage water consumption:
Normal flush – Uses 2 quarts (1 .9 liters) per flush . Adds water to bowl after every flush .
Dry Bowl flush – Uses 1 pint (0 .5 liter) per flush . Does not add water to bowl after flush .
To change from Normal to Dry Bowl flush setting, press “Flush” switch or flush handle for about five
seconds . When green light on status panel begins flashing, release “Flush” switch . Flush mode has
been changed to Dry Bowl setting . Change mode to Normal flush by following the same procedure .

FLUSH HANDLE

CONTROL

Add water

Flush