Reznor CK10 Option - Installation - Hanger Kit Installation - Unit Heaters - Manual (Page 3)

Form I-OPT-HK (Version A.1), Mfg #98346 (Rev 4), Page 3
so that the nut retainer is aligned with the clearance hole in the top of the side
panel. Insert the screw removed from the side panel through the center slotted
hole in the hanger bracket. Adjust the bracket so that it is tight against the top of
the heater. Tighten screw securely.
Following the same procedure, attach the other hanger bracket assembly at
the second location. Replace the outer side panel.
5. Remove the outer side panel from the opposite side and repeat Steps 2-4 on that
side.
6. Installation of the 4-point suspension hanger kit is complete. Since the crate bot-
tom has been removed, protect the bottom of the heater with plywood or other
appropriate material. If the bottom is not supported, the bottom access panel
could be damaged.
Follow the instructions in the heater installation manual to complete the
installation of your heater.
OPTION CK8 -
2-Pt Suspension
with Swivel
Connectors -
Models UDAP,
UDAS, and F
FIGURE 3A -
Hanger Kit,
Option CK8
The purpose of this option is to adapt a Model F heater with standard 2-point
suspension so that it can be suspended using two 1", threaded stationary pipes.
Option CK8 (Package P/N 98509) includes:
Qty Description P/N
2 Swivel Connector Assy 17627
2 3/8" Lockwasher 5197
Installation Instructions for Option CK8
Tools Required - 9/16" Open-End Wrench
Models UDAP and UDAS (FIGURE 3B)
1. Locate the threaded suspension holes in the top of the heater cabinet that are
used for 2-pt suspension (center holes).
2. Place a lockwasher over each hole.
3. Screw the swivel hanger connector assembly into the heater's cage nut retainer.
(The lockwasher must be between the top panel and the swivel hanger connec-
tor assembly.) Tighten firmly.
NOTE: If installing a Model UDAS, be certain that the unused suspension holes on
the control side are plugged. Follow the heater installation instructions.
CAUTION: Check to be
sure that all swivels turn
freely.
FIGURE 3B -
Model UDAP
or UDAS
(NOTE: Model F instructions
also apply to obsolete Model
FE.)
Model F (FIGURES 3C & 3D)
1. Locate the two hanger bracket holes in the top of the heater cabinet.
2. Place a lockwasher over the hole, being careful not to catch the cutout portion of
the painted side panel. The outer panel must remain removable for future ser-
vice. See FIGURE 3C.
3. Screw the swivel hanger connector assembly into the hanger bracket. (The
lockwasher must be between the inner heater side panel and the swivel hanger
connector assembly). Tighten firmly. See FIGURE 3D.
FIGURE 3C
- Model F
Do NOT
capture
outer panel; it must be
removable for future
service.