Perfect Aire PATWH14002 - Manual (Page 9)

TIMER: AUTO START/
STOP FEATURE:
Press “Timer”
button
DO THIS:
CHECK FILTER FEATURE:
Press “Check
Filter” button
DO THIS:
Energy
Saver
on off
Timer
Auto
Fan
Cool
Dry
Mode
TEMP/TIMER
TEMP/TIMER
Sleep Check
Filter
Follow
Me
Auto
On/off Fan
High
Med
Low
on off
Timer
TEMP/TIMER
TEMP/TIMER
FOLLOW ME FEATURE:
(on some models)
CLEAN AIR FEATURE:
(on some models)
Light flashing
Sleep Check
Filter
Follow
Me
Auto
On/off Fan
High
Med
Low
on off
Timer
TEMP/TIMER
TEMP/TIMER
Clean
Air
Press “Clean
Air” button
DO THIS:
Energy
Saver
on off
Timer
Auto
Fan
Cool
Dry
Mode
TEMP/TIMER
TEMP/TIMER
Clean
Air
NOTE: TIMER button
First press the “Timer” button. The indicator light
beside the word “On” will illuminate indicating the Auto
Start program is on.
Press or hold the Up or Down Temp/Timer arrows to
change the Auto time by 0.5 hour increments, up to 10 hours,
then at 1 hour increments up to 24 hours.
The control will count down the time remaining until start.
The selected time will register for 5 seconds and the
system will automatically revert back to display the previous
temperature setting.
When the “Timer On” is displayed, press the “Timer” button
again and the “Timer Off” indicator light illuminates. It indicates
the Auto Stop program is initiated.
Turning the unit on or off at any time or adjusting the timer setting
to 0.0 will cancel the Auto Start/Stop function.
This feature is a reminder to clean the Air Filter for
more efficient operation. The LED (light) will illuminate after
250 hours of operation. To reset after cleaning the filter, press
the “Check Filter” button and the light will go off.
NOTE: CHECK FILTER button
NOTE: FOLLOW ME indicator light
NOTE: CLEAN AIR button
To activate the Follow Me feature, point the remote control
towards the unit and press the “Follow Me” button. The remote
displays the actual temperature at its location. The remote control
will send this signal to the air conditioner every 3 minutes
until the “Follow Me” button is pressed again. If the unit does
not receive the “Follow Me” signal during any 7 minute interval,
the unit will beep to indicate the Follow Me mode has ended.
The actual temperature can be displayed at the unit by
pressing the “Fan” only mode. When in the “Cool” mode, the
unit display indicates the set temperature.
Press the “Clean Air” button.The ion generator is
energized and will help to remove pollen and impurities
from the air and trap them in the filter.
This feature can ONLY be activated from the remote control.
The remote control serves as a remote thermostat allowing for
precise temperature control at its location.
AIR CONDITIONER FEATURES (CONTINUED)
8