Perfect Aire PATWH14002 - Manual (Page 7)

TO TURN UNIT ON:
NOTE: The following instructions represent the Unit Controls. The same instructions can be used
for the Remote Control.
TO CHANGE TEMPERATURE SETTING:
Press the On/Off button.
DO THIS:
Press to raise
DO THIS:
Press to lower
Press or hold either Up ( ) or Down ( ) button
until the desired temperature is seen on the
display. This temperature will be automatically
maintained anywhere between 62ºF(17ºC) and
86ºF(30ºC).If you want the display to read
the actual room temperature, see “To Operate
on Fan Only” section.
NOTE: UP/DOWN button
TO ADJUST FAN SPEEDS:
Press “Fan” to
select fan speed
DO THIS:
NOTE: FAN button
Sleep Check
Filter
Follow
Me
Auto
On/off Fan
High
Med
Low
on off
Timer
TEMP/TIMER
TEMP/TIMER
Energy
Saver
on off
Timer
Auto
Fan
Cool
Dry
Mode
TEMP/TIMER
TEMP/TIMER
Sleep Check
Filter
Follow
Me
Auto
On/off Fan
High
Med
on off
Timer
TEMP/TIMER
Clean
Air
There are four (4) fan speeds: “Auto,” “Low,”
“Med” or “High.” Each time the button is pressed,
the fan speed mode is shifted. On “Dry” mode
the fan speed is controlled at low automatically.
For some models with heating capabilities, the
fan speed cannot be adjusted under “Heat” mode.
NOTE: The unit will automatically initiate the
Energy Saver function under “Cool,” “Dry” and
“Auto” (only Auto-Cooling and Auto-Fan) modes.
AIR CONDITIONER FEATURES (CONTINUED)
Energy
Saver
on off
Timer
Auto
Cool
Dry
Mode
TEMP/TIMER
TEMP/TIMER
Clean
Air
DISPLAYS:
Displays
6
NOTES:
- If the unit breaks off unexpectedly due to power
being cut, it will restart with the previous function
setting automatically when the power resumes.
- In “Fan” only mode, unit will display “Lo” or “Hi”.
Error Codes:
AS - Room temperature sensor error - Unplug the
unit and plug it back in. If error repeats, call
customer service.
- Evaporator temperature sensor error -
Unplug the unit and plug it back in. If error
repeats, call customer service.
(“ ” is displayed as shown in left picture.)
HS - Electric heating sensor error - Unplug the
unit and plug it back in. If error repeats, call
customer service.
NOTE: DISPLAYS
Shows the set temperature in “°C” or “°F” and the
Auto-timer settings. While on “Fan” only mode, it
shows the room temperature.