Perfect Aire PATWH14002 - Manual (Page 11)

Items in Kit
You may not need all parts in the kit. Discard unused parts.
Item Dimensions (if applicable) Quantity
Tapered Spacer Blocks 17” Long 2
Centering/Support Blocks 4 1
/
2
” x 3 1
/
2
” x 1 1
/
2
” 4
Plastic Divider 1
/
8
” x 4 1
/
2
” x 14 1
/
2
” 2
Stuffer Seal 1” x 1 1
/
2
” x 84” 1
Seal 1” x 1 1
/
2
” x 25” 3
Seal 1” x 1 1
/
2
” x 14” 2
Seal 1” x 3
/
8
” x 25” 3
Seal 1” x 3
/
8
” x 14” 2
Seal 1” x 3
/
4
” x 14” 2
Trim Frame (side legs) 2
Trim Frame (top & bottom legs) 2
Ground Wire (green) 1
Toothed washer for grounding screw 2
Grounding Screw 1
Grille (plastic) 1
Grille (aluminium) 1
Nuts (plastic) 4
Screw Washer 4
Screw 4
How to Install
1. Identify the wall-sleeve brand for your installation, from the chart below.
Wall Sleeve Dimensions
REAR
LEVEL
FRONT UNIT
WALL
SLEEVE
1 /
4 to 5
/
16
RUBBER
CLAMP
Perfect Aire, Frigidaire,
White-Westinghouse, 25 1
/
2
” 15 1
/
4
”
16”, 17 1
/
2
”
Carrier (52F Series)
or 22”
General Electric, Hotpoint 26” 15 5
/
8
” 15 7
/
8
”
Whirlpool 25 7
/
8
” 16 1
/
2
” 17 1
/
8
” or 23”
Fedders, Emerson 27” 16 3
/
4
” 16 3
/
4
” or 19 3
/
4
”
Sears/Kenmore,
Carrier (51S Series) 25 3
/
4
” 16 7
/
8
” 18 5
/
8
”
Fedders, Emerson 26 3
/
4
” 15 3
/
4
” 15”
Friedrich 27” 16 3
/
4
” 16 3
/
4
”
Brand Width Height Depth
Note:
Note:
Please verify dimensions
of your wall sleeve with
its manufacturer before
installing your thru-the-
wall unit.
All wall sleeves used to mount the new air conditioner must be in sound structural condition and have a
rear grille that securely attaches to sleeve, or rear flange that serves as a stop for the air conditioner.
Caution: When installation is complete, replacement
unit MUST have a rearward slope as shown. Ensure
the RUBBER CLAMP on the chassis at the back of
the unit had been removed before placing the unit
into the sleeve. However, if the rearward slope is
more than ½”, do not remove the Rubber Clamp
before installation.
2. Remove old air conditioner from wall sleeve and prepare wall sleeve as follows:
Clean interior. (Do not disturb seals.)
Wall sleeve must be securely fastened in wall before installing air conditioner.
Drive more nails or screws through sleeve, into wall, if needed.
Repair paint if needed.
INSTALLATION INSTRUCTIONS (CONTINUED)
10