Perfect Aire PATWH14002 - Manual (Page 8)

TO SELECT THE
OPERATING MODE:
Press the
“Mode” button.
DO THIS:
TO USE THE ENERGY
SAVER FEATURE:
Press the
“Energy Saver”
button
DO THIS:
SLEEP FEATURE:
Press “Sleep”
button
DO THIS:
In this mode the selected temperature will increase
(cooling) or decrease (heating - units with heater only)
by 2 O F/1 O C 30 minutes after the mode is selected.The
temperature will then increase (cooling) or decrease
(heating - units with heater only) by another 2 O F/1 O C
after an additional 30 minutes. This new temperature
will be maintained for 6 hours before it returns to the
originally selected temperature. This ends the Sleep
mode and the unit will continue to operate as originally
programmed. The Sleep mode program can be
cancelled at any time during operation by again
pressing the “Sleep” button.
NOTE: SLEEP button
Energy
Saver
on off
Timer
Auto
Fan
Cool
Dry
Mode
TEMP/TIMER
TEMP/TIMER
Heat
Energy
Saver
on off
Timer
Auto
Fan
Cool
Dry
Mode
TEMP/TIMER
TEMP/TIMER
Sleep Check
Filter
Follow
Me
Auto
On/off Fan
High
Med
Low
on
off
Timer
TEMP/TIMER
TEMP/TIMER
Clean
Air
Clean
Air
To choose operating mode, press the “Mode” button.
Each time you press the button, a mode is selected in a
sequence that goes from “Auto,” “Cool,” “Dry,” “Heat,”
(for units with heating function) and “Fan.” The indicator
light will be illuminated and remain on once the mode
is selected. The unit will automatically initiate the
Energy Saver function under “Cool,” “Dry,” and
“Auto” (only Auto-Cooling and Auto-Fan) modes.
NOTE: MODE button
To operate on “Auto” feature:
To operate on “Fan” only (not available on all models):
Use this function only when cooling is not desired,
such as for room air circulation or to exhaust stale
air. (Remember to open the vent during this function,
but keep it closed during cooling for maximum cooling
efficiency.) You can choose any fan speed you prefer.
During this function, the display will show the actual
room temperature, not the set temperature as in the
cooling mode.
NOTE: ENERGY SAVER button
To operate on “Dry” mode:
In this mode, the air conditioner will reduce air
humidity. If the space is a closed or sealed area, some
degree of cooling will continue.
When you set the air conditioner in “Auto” mode, it will
automatically select cooling, heating (on models with
heating capabilities), or fan only operation depending on
what temperature you have selected and the room
temperature.The air conditioner will control room
temperature automatically around the temperature you set.
In this mode, the fan speed cannot be adjusted.
It starts automatically at a speed according to the
room temperature. If the room does not get too warm,
it will stay at “Low” speed.
This function is available on “Cool,” “Dry,” and “Auto”
(only Auto-Cooling and Auto-Fan) modes. In this
mode,the fan will continue to run for 3 minutes after the
compressor shuts off.The fan then cycles on for 2
minutes, at 10 minute intervals, until the room
temperature is abovethe set temperature, at which
time the compressor turns back on and cooling starts.
AIR CONDITIONER FEATURES (CONTINUED)
7