Program, Programming track numbers, Clearing the program – Philips FWR7R37 User Manual
Page 33: Erasing a track from the program, Making a program for recording
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PROGRAM
Programming track numbers
You can select tracks and store them either in the CD changer
or CD recorder memory. If you use the program for playback you
can choose one of the two memories, else if you like to specify
tracks for recording, use the CD changer memory only! You can
store any track more than once.
1 Load the desired disc(s) in the disc tray(s).
2 Press either CD 1, CD 2, CD 3, or CDR to select the disc.
3 Press PROG on the unit (PROGRAM on the remote control).
-►PROG
starts blinking and
Program
is displayed.
4
If either CD
/,
CD 2 or CD 3 is selected:
Rotate JOG CONTROL to select either:
-►CDl (or 2, 3) All: All tracks of CD 1 (or 2, 3) will be
programmed.
-►CDl (or 2, 3) and track number: The track number of
CD 1 (or 2, 3) will be programmed.
If CDR is selected:
Rotate JOG CONTROL (press the numerical keys on the
remote control; for 2-digit numbers, press the keys in rapid
succession) to select a track number.
5 Press YES to store your selection in the memory.
-►The number of programmed tracks
(
step
). Prog
and the
total program time are displayed. The track number
blinks in the music calendar.
6
Select and store all desired tracks in this way.
7 Press PROG on the unit (PROGRAM on the remote control)
to end programming.
-►PROG
stays shown and the program is currently available.
Note: If the maximum number of programmable tracks is
reached, the display shows
Progr.arn f u 11.
Erasing a track from the program ______ _______ |
1
If necessary, press STOP □ on the unit (■ on the remote
control) to stop playback.
2 Press either CD 1, CD 2, CD 3, or CDR to select the desired
memory.
3 Press PROG (PROGRAM on the remote control), followed by
control) to move through the program steps. -►The track number at the selected step and the total program time are displayed. 4 Press NO to remove the track from the program. -►Cleared is displayed briefly. -►The next programmed track number will move up to this position and is displayed together with the step number and the remaining total program time. Clearing the program 1 If necessary, press STOP □ on the unit (■ on the remote control) to stop playback. 2 Press NO. -►Clear Prog? is displayed. 3 Press YES to clear the program. -►Prog Cleared will be displayed and PROG goes off. Note: l/Vhen you open the CD recorder tray or the CD changer tray the respective program will be cleared. Making a program for recording ________________| 1 Select and store all desired tracks in the CD changer memory (see "Programming track numbers"). 2 Enter the recording menu (see "Internal recording"). • If the total time of the program is of larger size than the remaining recording time of the CDR(W): -►Not f i tting! will be displayed briefly, followed by the remaining recording time and Record Prog? If you nevertheless start recording, only those tracks of the program that fit onto the CDR(W) will be recorded in entirety. •To change the program, press NO. -►Edit Progr.am will be displayed briefly, prog and the time of the program start blinking. Now you can change the program (see "Programming track numbers", "Erasing a track from the program" and "Clearing the program"). "в»: e ^ 17