Canon PC 140 - Manual (Page 37)

Operating Procedure
35
2
Postcards,
Transparencies* and
Other Stock
It is possible to make copies onto
postcards, transparencies and a
variety of copy stock.
Various Ways Various Ways
to Copy
to Copy
V
arious W
ays to Copy
Adjust the paper feed guides to fit the
width of the copy stock.
Place the original to be copied copy side
down onto the platen glass.
(See “Positioning Originals” on p. 32.)
Gently close the platen cover.
Insert the copy stock into the multi-stack
tray.
When inserting the paper into the multi-
stack tray, make sure the edges are even
and slide it into the copier as far as it will
go.
• Do not load more than a 5 mm high stack
of copy paper (1/5 in. or up to 50 sheets of
20 lb-bond copy paper) into the multi-stack
tray at one time.
• Insert transparencies into the multi-stack
tray and copy one at a time only.
Press the key.
NOTICE:
• When copying onto a folded card, align the
center of the original with the
← mark on the
guide plate and then align the flattened copy
stock to match the
← as well. Finally, align the
paper feeding guides to fit the stock size.
• Copy transparencies one at a time and remove
each transparency from the copy tray as it is
copied to prevent transparencies from sticking.
• Do not make copies with paper which has
already been printed on using a thermal transfer
printer. Copying with this stock may adversely
affect the quality of the copied images or cause
a paper jam. If you want to copy with it first
make a copy of the thermal transfer printed
paper onto standard copy stock.
MEMO:
• When copying on thick stock such as postcards
there is a chance that letters could be blurred.
• Some types of transparencies may blur when
used in this copier. To avoid this, use
transparencies recommended for use with your
copier. For details, contact your dealer or Canon
Customer Relations.
*Canon type E.