Canon PC 140 - Manual (Page 21)

Getting Started
19
1
Rock the cartridge several times to the
right and left at a 90
° to evenly distribute
the toner within the cartridge.
Remove the cartridge sealing tape.
(See “Replacing Cartridges”, on p. 21.)
Insert the cartridge into the copier.
Close the top cover by pressing down
firmly on the button.
Return the platen to the center position.
Plug the power cord into an electrical
outlet.
WARNING:
• This copier is only designed for use with the
power source shown on the marking label
located on the back of the copier. If you are
unsure of the power source, check with your
local power company.
NOTICE:
• If the copier is brought in from a cold place to a
warm one, or if the location of the copier should
be rapidly heated, condensation will form inside
the copier. This may adversely affect the quality
of the copy images (e.g., blacked-out copies).
When the copier is exposed to such conditions,
allow at least two hours for the copier to adjust
to room temperature before attempting to
operate it.
Replacing and Replacing and
Storing
Storing
Cartridges
Cartridges
About the Cartridge
The cartridges for use in this
copier are the Canon Cartridge
E20 (Black) or the Canon
Cartridge E (in Red, Blue, Green
or Sepia) is also available. Each
cartridge is a consumable item
and should be replaced when the
toner runs out. Replacing and Storing Cartridges