Citizen Systems CBM-270 - Manual (Page 54)

CBM-270 User’s Manual
ESC
−
n
[Function] Specifying/Canceling underline
[Code] <1B> H <2D> H
[Range] 0
≤
n
≤
2
[Outline] Specifying/canceling an underline.
•
Types of underlines by n value are shown below:
n Type
0 Canceling an underline.
1 Specifying an underline for 1-dot width
2 Specifying an underline for 2-dots width
[Caution]
•
An underline is attached to the full character width. It is, however, not attached to the
part having been skipped by horizontal tab command.
•
An underline is not attached to a 90
°
- right-turned characters.
•
Specification/cancellation with this command is invalid to Kanji.
[See Also] ESC !, FS
−
[Sample Program]
LPRINT CHR$ (&H1B) ; "
−
" ; CHR$ (0) ;
LPRINT "AAAAA" ;
LPRINT CHR$ (&H1B) ; "
−
" ; CHR$ (1) ;
LPRINT "AAAAA" ; CHR$ (&HA) ;
END
[Print Results]
ESC 2
[Function] Specifying 1/6-inch line feed rate
[Code] <1B> H <32> H
[Outline] The line feed rate per line is specified by 1/6 inch.
[Sample Program] [Print Results]
LPRINT "AAAAA" ; CHR$ (&HA) ;
LPRINT CHR$ (&H1B) ; "3" ; CHR$ (0) ;
LPRINT "AAAAA" ; CHR$ (&HA) ;
LPRINT CHR$ (&H1B) ; "3" ; CHR$ (50) ;
LPRINT "AAAAA" ; CHR$ (&HA) ;
LPRINT CHR$ (&H1B) ; "2" ;
LPRINT "AAAAA" ; CHR$ (&HA) ;
LPRINT "AAAAA" ;
LPRINT CHR$ (&H1B) ; "J" ; CHR$ (100) ;
LPRINT "AAAAA" ; CHR$ (&HA) ;
LPRINT "AAAAA" ; CHR$ (&HA) ;
ESC 3 n
[Function] Setting line feed rate of minimum pitch
[Code] <1B> H <33> H