Citizen Systems CBM-270 - Manual (Page 27)

CBM-270 User’s Manual
4.6 FEED Switch Function
4.6.1 When Thermal Paper is Used
Pressing the switch, feed the paper by 1 line. If the switch is held down, the paper will be fed
continuously.
4.6.2 When Label Paper is Used
Pressing the switch, feed the paper by 1 line. If the switch is held down for 1 second or more, the paper
will be fed by one label.
4.6.3 When the Macro is Executed
If the ERROR lamp is blinking while waiting for execution of a macro, press the FEED switch. The
waiting state continues until the switch is pressed.
4.6.4 When the Label is Fed to the Paper Cutting Position by the Command
The PAPER lamp blinks. After cutting the paper, pressing the FEED switch searches for the head of the
next label. The waiting state continues until the switch is pressed.
CAUTION:
If the label paper is fed by 1 line by pressing the FEED switch, the label head position will be dislocated. Note
that if printing starts in this state, the label will be printed dislocated. (It is recommended to feed the paper by 1
label.)
4.7 Paper End Function
If the printing paper runs out, the parallel interface will output BUSY, FAULT, and PE to the host, and the
serial interface will output DTR to stop printing, respectively. If some data are still remaining in the buffer,
printing will be resumed after replacing the paper. Replace the paper according to "4.3 Inserting the Paper."
After replacing the paper, cancel BUSY (DTR), FAULT, and PE outputs. For details, see "4.8 Near Paper
End Function."