Canon C2550 - Manual (Page 90)

Setting Up a Computer for Printing/Sending a Fax 3-48
3
Usin
g a
TCP/IP Netw
or
k
Mac OS X
1
Check the settings for in [IP Address Range
Settings] on the IPv4 or IPv6 Settings screen to see whether
the IP address of the computer in which a driver is to be
installed is permitted. For details, see step 17 in "TCP/IP
Settings (IPv4)," on p. 3-3 or step 6 in "TCP/IP Settings (IPv6),"
on p. 3-18.
IMPORTANT
• If the settings for in [IP Address Range Settings] on the IPv4 or
IPv6 Settings screen do not permit the IP address, you cannot install a driver.
• If the IP address of the computer is beyond the range of the permitted addresses
set for after installing a driver, you cannot print or send a fax
from the computer.
2
Install the driver.
Install the driver according to the instructions in the manual for each driver.
• If you want to use the UFR II printer driver
See the
Mac UFR II Driver Guide .
• If you want to use the PS printer driver
See the
Mac PS Driver Guide .
• If you want to use a PS printer driver provided by Apple Inc.
For instructions on how to install the corresponding PPD file from Canon, see
the
Network Quick Start Guide . For details about the PS printer driver, see the
documentation provided with your Macintosh.
IMPORTANT
• If you are using the optional imagePASS, for details, see the manual provided with
the optional imagePASS.
• The PS printer driver can be used only in a Mac OS X 10.3.9 or later environment.
UNIX
The machine supports the LPD print application for printing over TCP/IP networks.
The following procedures are only examples. The setup procedures for your
environment may differ.
IMPORTANT
If the settings for in [IP Address Range Settings] on the IPv4 or IPv6
Settings screen do not permit the IP address, you cannot specify the spooling system.