Canon C2550 - Manual (Page 57)

Protocol Settings 3-15
3
Usin
g a
TCP/IP Netw
or
k
IMPORTANT
• You can register up to eight IPv4 addresses or IPv4 address ranges.
• The IPv4 address '0.0.0.0' cannot be specified.
• The value of [First Address] for [Multiple Addresses] should be smaller than or
equal to that of [Last Address].
• If is set to 'Off' for both [Permit IPv4 Address] and [Reject IPv4
Address], all IPv4 addresses are permitted.
• If is set to 'Off' for [Permit IPv4 Address] and is
set to 'On' for [Reject IPv4 Address], IPv4 addresses that are beyond the specified
range of [Reject IPv4 Address] are permitted.
• If is set to 'On' for [Permit IPv4 Address] and is
set to 'Off' for [Reject IPv4 Address], IPv4 addresses that are beyond the specified
range of [Permit IPv4 Address] are not permitted.
• If for both [Permit IPv4 Address] and [Reject IPv4 Address] is set
to 'On', IPv4 addresses that are beyond the ranges of both [Permit IPv4 Address]
and [Reject IPv4 Address] are not permitted.
• If for both [Permit IPv4 Address] and [Reject IPv4 Address] is set
to 'On', IPv4 addresses that are within the ranges of both [Permit IPv4 Address]
and [Reject IPv4 Address] are not permitted.
• If the usage of a protocol or print application is not permitted on your device, it
cannot be used even after its IPv4 address is permitted on the machine; on your
device, configure the settings to permit the protocol or print application.
NOTE
This machine logs attempts to gain access from IPv4 addresses that it has been
set to reject. For instructions on how to refer to the access log, see "Viewing the
Network Access Log," on p. 8-24.
18
On the TCP/IP Settings screen, press [Permitted Receiving
MAC Address Settings]
➞ specify the following.
[On] for : You can enable a MAC address filter. Press [Register]
➞ specify the MAC addresses to allow access to.