Oakworks Relaxation Lounge - Manual (Page 11)

INSTALLATION
InsTallaTIon
INSTALLATION
• Leveling Instructions
The Relaxation Lounge™comes completely assembled and ready to use.
Plug the cord into a functioning outlet that is rated for the table.
Arrange the power cord and control cords so that they will not create a tripping
hazard. Place the controls in a safe location where they are convenient and
accessible. Keep the controls out of the way of all table mechanisms.
leVelInG InsTrUCTIons:
If Lounge Will Not Sit Flat on the Floor:
The Relaxation Lounge™is equipped with Leveler Feet that adjust to
level the table on uneven floors. To adjust the Leveler Feet to suit
common floor differences you will need to use a
1 /
2
” open-end wrench
or an adjustable wrench. Adjust each leg individually in turn by adjusting
the height of each leveler foot until the unit rests level and steady. This
adjustment will not effect the function of the table.
1/2” Open-end Wrench Leveler foot
CaUTIon
The table weighs as much
as 250 lbs. Do Not lift or
move the unit without using
proper safety procedures
or equipment. Do Not turn
the
Relaxation Lounge™
on its side for any reason. To
do so could cause damage
to the base and will void
the warranty. There are no
serviceable items that require
this action.
Never lift the table by
grasping the table top as the
table top is not
designed to
hold the weight of the base
and you could damage the
table.
• Leveling Feet
When operating the
Relaxation Lounge™
controls be sure to observe all
cautions and warnings given
in the manual to prevent injury
to both operator and client.
IMpORTANT 8
4